The short answer
Codes in the 100s are usually the grid, not the inverter, and often clear by themselves. 306 and 307 at dawn or dusk are normal. Codes in the 400s and above usually need a technician.
Where to find the code
When a Fronius inverter is not feeding power in, its screen shows STATE followed by a three-digit number, and the same code appears in the Fronius Solar.web app if the system is connected. Take a photo of the screen, or a screenshot of the app, with the date and time.
The first digit gives you a good idea of where the problem is:
| Codes | Where to look | Usually |
|---|---|---|
| 100s | The grid: the voltage or frequency from the utility | Clear by themselves when the grid settles |
| 300s | The solar side: what is coming in from the panels | Normal at dawn, dusk and in heavy cloud. All day means a DC problem. |
| 400s | Inside the inverter, or the parts talking to each other | Need a technician |
| 500s | Warnings and information | The inverter may still be running. Worth a look. |
| 600s and up | Hardware inside the inverter | Need a technician |
The codes we see most
| Code | What it means | What to do |
|---|---|---|
| 102 | Grid voltage too high | Common on sunny afternoons when many homes on the street export at once. If it happens most days, we measure it and may need the utility. |
| 103 | Grid voltage too low | Often a grid problem or a loose connection. If it repeats, call. |
| 105, 106 | Grid frequency too high or too low | Usually during or right after a power cut. Wait for it to clear. |
| 107 | No grid detected | Check the solar breaker and AC disconnect. If they are on and the house has power, call. |
| 306 | Power low: not enough power from the panels to feed in | Normal at dawn and dusk. All day in full sun points to a DC problem. |
| 307 | DC low: the panel voltage is too low to start | Normal in low light. All day in full sun: check the DC switch, then call. |
| 509 | No energy fed in for the last 24 hours | Look for another code that explains why, and check the breakers. |
Tip. If you see 306 or 307 at sunrise and sunset and a normal power reading at midday, that is a healthy inverter starting and stopping with the light.
Can I reset it?
Grid codes in the 100s clear themselves: the inverter waits until the grid is back in range for a few minutes, then starts again. For other codes, one restart is fine: follow the safe shut-down and restart order. If the same code comes back, leave it and call us with the photo.
Models we see in Arizona
- Fronius IG Plus: an older line, many now past warranty. When one fails, a replacement is usually the better value.
- Fronius Galvo and Primo: very common on homes from the 2010s. Primo units have a Datamanager card for Wi-Fi monitoring.
- Fronius Symo and Primo GEN24: newer models, some with battery support.
Fronius warranties vary by model and whether the owner registered the inverter. Send us the serial number from the label and we can check.
Questions people ask
My Fronius shows 102 every summer afternoon. Is it broken?
Probably not. 102 means the grid voltage the inverter sees is too high. It is common on sunny afternoons when many homes on the street export at once. If it happens often, we can measure the voltage, and it may need the utility or a wiring change.
This guide is general advice for Arizona homeowners. Your equipment's manual has the final word, and anything inside the inverter, on the roof or in the electrical panel is a job for a licensed contractor.






